The nRF70 Wi-Fi driver's power-save event handler nrf_wifi_event_proc_get_power_save_info() in drivers/wifi/nrf_wifi/src/wifi_mgmt.c copied TWT (Target Wake Time) flow entries from an nrf_wifi_umac_event_power_save_info event into the fixed-size twt_flows[WIFI_MAX_TWT_FLOWS] (8-element) array of a caller-supplied struct wifi_ps_config, looping over event-provided num_twt_flows without validating it against WIFI_MAX_TWT_FLOWS or checking event_len. When num_twt_flows exceeds 8, the handler writes past the destination array (which is typically on the caller's stack, e.g. the wifi ps shell command) -- an out-of-bounds write of ~40-byte TWT entries -- and reads twt_flow_info[i] past the event buffer. The event is delivered by the nRF70 co-processor firmware in response to a host-initiated power-save GET, so reaching the overflow requires the firmware to emit a malformed or out-of-range event; the trust boundary is host-to-trusted-coprocessor rather than a direct remote-AP write, with over-the-air influence on the flow count being indirect and bounded by the 3-bit TWT flow-id space. Affected: builds with CONFIG_NRF70_STA_MODE on releases through v4.4.0. The fix rejects events with num_twt_flows > WIFI_MAX_TWT_FLOWS or with event_len shorter than the claimed entries, and adds a NULL check on the caller buffer.

parse_ipv4() in subsys/net/ip/utils.c (reached via net_ipaddr_parse() for strings of the form "a.b.c.d:port") copies the port substring into a fixed 17-byte stack buffer (char ipaddr[NET_IPV4_ADDR_LEN + 1]) using a length of str_len - end - 1, where str_len is the full, unbounded input length and end is only the (<=15-byte) offset of the ':' delimiter. Because the destination size is never consulted, a crafted address string with a long suffix after the colon (e.g. "1.2.3.4:" followed by hundreds of bytes) causes an out-of-bounds stack write whose length and contents are fully attacker-controlled (memcpy of the suffix plus a trailing NUL), enabling memory corruption and at minimum a denial of service, and potentially control-flow hijack. The parser is reached from the standard socket API (zsock_getaddrinfo / literal-address resolution), DNS server-string configuration, and the eswifi Wi-Fi co-processor DNS-response path, so an application that resolves a network-influenced address string is exposed. The bug was introduced when the parser was added (Zephyr v1.9.0) and shipped in all releases through v4.4.0. The fix removes the unbounded copy and validates the port length before copying into a small dedicated buffer. Note: the equivalent IPv6 "[addr]:port" path in parse_ipv6() retains the same unbounded copy at this commit and remains a separate, still-reachable instance of the defect.

In Zephyr's experimental USB host stack (CONFIG_USB_HOST_STACK), usbh_device_disconnect() (subsys/usb/host/usbh_device.c) freed the root usb_device slab object without clearing the cached pointer ctx->root. The bus removal handler dev_removed_handler() (subsys/usb/host/usbh_core.c) decides what to tear down solely from ctx->root, checking only that it is non-NULL. Because UHC controller drivers (e.g. uhc_max3421e, uhc_mcux_common) synthesize UHC_EVT_DEV_REMOVED directly from physical bus line state with no debounce or state guard, an attacker with physical USB access (or a rogue device that bounces its connection) can deliver a second device-removed event after a root device disconnect. The handler then re-enters usbh_device_disconnect() with the dangling pointer, locking a mutex inside the freed object (use-after-free), removing the freed node from the device list, and calling k_mem_slab_free() on the already-freed block (double-free). If the slab block has been reissued to a newly attached device in between, this corrupts a live object. Impact is denial of service (crash) and memory corruption; the attack vector is physical/local. The flaw was introduced in v4.4.0 by the connect/disconnect refactor and is fixed by clearing ctx->root in usbh_device_disconnect() before freeing.

In Zephyr's WireGuard subsystem (subsys/net/lib/wireguard), wg_process_data_message() in wg_crypto.c linearizes an inbound transport-data payload into a fixed pool buffer of CONFIG_WIREGUARD_BUF_LEN bytes before decryption. The call net_buf_linearize(buf->data, data_len, pkt->buffer, ..., data_len) passed the attacker-derived data_len as both the destination capacity and the copy length, defeating the function's internal len = min(len, dst_len) bound. data_len is derived from the received UDP datagram length and is only lower-bounded by wg_ctrl_recv() (no upper bound). When data_len exceeds CONFIG_WIREGUARD_BUF_LEN — e.g. when the buffer length is lowered below the link MTU, on links with MTU above the buffer size, or via reassembled IPv4/IPv6 fragments that exceed it — the underlying memcpy writes past the end of the pool buffer, an out-of-bounds write (CWE-787). The overflow occurs before the Poly1305 authentication check, so it requires only a valid receiver session index rather than a valid authenticator, and is reachable by a malicious or compromised peer (or an on-path attacker driving an established session) over the network, yielding remote memory corruption and at minimum a reliable denial of service. The defect was present in the WireGuard implementation shipped in Zephyr 4.4.0. The fix adds an explicit data_len > CONFIG_WIREGUARD_BUF_LEN rejection and corrects the linearize call to pass net_buf_max_len(buf) as the destination capacity.

The Bluetooth BAP Broadcast Assistant GATT client in subsys/bluetooth/audio/bap_broadcast_assistant.c reassembled remote Broadcast Receive State data into a single file-static net_buf_simple (att_buf, BT_ATT_MAX_ATTRIBUTE_LEN = 512 bytes) shared by all connection instances, while the BUSY flag, long-read handle, and reset/offset state were per-connection. When the device acts as a Broadcast Assistant connected to multiple Scan Delegator peripherals, notification and long-read callbacks from different connections interleave on the shared buffer: the append in notify_handler (net_buf_simple_add_mem at the not-busy branch) performs no tailroom check, so receive-state notifications from two or more delegators accumulate on the same 512-byte buffer and, with a sufficiently large configured ATT MTU (BT_L2CAP_TX_MTU up to 2000) and two-to-three concurrent connections, write past the buffer into adjacent .bss (net_buf_simple_add only asserts in debug builds). Even below the overflow threshold, one connection's net_buf_simple_reset zeroes the shared length while another connection's reassembly and GATT read offset are in flight, mixing one peer's data into another's parse. A malicious or compromised Scan Delegator (or two colluding peers) over BLE can trigger this, causing out-of-bounds writes (memory corruption / denial of service) and cross-connection data corruption. The fix moves the buffer into the per-connection instance struct so each connection reassembles into its own buffer. Affects Zephyr releases shipping the Broadcast Assistant with the shared buffer, including v4.4.0 and earlier.

The Dhara flash translation layer disk driver (drivers/disk/ftl_dhara.c) implemented the dhara_nand_ callbacks so that, on a flash error, the error code was written unconditionally through the caller-supplied dhara_error_t err pointer (e.g. *err = DHARA_E_ECC in dhara_nand_read, and similar in dhara_nand_erase/prog/copy). The upstream Dhara library calls these callbacks with err == NULL along its journal-resume binary search: find_last_checkblock() invokes find_checkblock(j, mid, &found, NULL), which forwards the NULL pointer into dhara_nand_read(). This path runs during disk_ftl_access_init() -> dhara_map_resume() whenever the FTL disk is mounted/initialised. If a flash read error (uncorrectable ECC, bad block, controller error) occurs on one of the probed checkpoint pages, the driver dereferences and writes to NULL, faulting the kernel (denial of service). The trigger is conditioned on the NAND medium content/health, which can be influenced by media wear, induced faults, or a corrupted/crafted on-flash image. The fix routes all error assignments through the library's NULL-safe dhara_set_error() helper. Affects Zephyr v4.4.0, where the driver was introduced.

Zephyr's DNS resolver detects mDNS (.local) queries in dns_resolve_name_internal() (subsys/net/lib/dns/resolve.c) with memcmp(strrchr(query, '.'), ".local", 7), which always reads a fixed 7 bytes from the suffix pointer. When the resolved hostname's final label is shorter than 7 bytes (e.g. names ending in .org, .com, .net, .io, or a trailing dot), the comparison reads 1-2 bytes past the string's NUL terminator. The hostname (query) is the caller-supplied name passed through the standard getaddrinfo()/dns_get_addr_info()/dns_resolve_name() path and is influenceable by operators or remote inputs (server names from configuration, parsed URLs, or app-facing interfaces). On a tightly-sized buffer with no slack (for example a userspace getaddrinfo call where the hostname is copied with k_usermode_string_alloc_copy to exactly strlen+1 bytes), the over-read crosses the allocation boundary; if that boundary is unmapped (guard page, memory-domain boundary under MPU, or an address sanitizer) the over-read faults, causing a denial of service. The over-read bytes are never returned, so there is no information disclosure. The flaw is compiled only when CONFIG_MDNS_RESOLVER is enabled, exists since v1.10.0, and is fixed by replacing the fixed-length memcmp with a NUL-safe strcmp(ptr, ".local").

The MAX32xxx USB device controller driver (drivers/usb/udc/udc_max32.c, compatible adi_max32_usbhs) dereferenced an endpoint buffer in its OUT and IN transfer-completion handlers without checking it for NULL. udc_event_xfer_out_done() called net_buf_add(buf, ep_request->actlen) immediately after buf = udc_buf_get(ep_cfg), where udc_buf_get() returns NULL when the endpoint FIFO is empty. A transfer-completion event is queued from interrupt context and processed asynchronously by the driver thread; between queuing and processing, the endpoint FIFO can be drained by host-controlled control flow — in particular udc_setup_received() drains the EP0 OUT/IN FIFOs whenever a new SETUP packet arrives, and dequeue/disable/purge paths drain it likewise. A USB host that aborts an in-flight EP0 control transfer with a new SETUP packet (legal USB behavior) can therefore cause a stale XFER_OUT_DONE event to be processed against an empty FIFO, producing net_buf_add(NULL, ...), a near-NULL pointer dereference that faults and crashes the device. No authentication is required; the attacker is the USB host the device is connected to (physical bus access). Impact is denial of service (device crash). The defect was introduced when the MAX32 UDC driver was added and shipped in Zephyr v4.4.0. The fix adds NULL-buffer checks that return early with UDC_EVT_ERROR/-ENOBUFS in both the OUT-done and IN-done handlers.

The Zephyr net_buf library (lib/net_buf/buf.c) manipulated both of its reference counts -- the per-header buf->ref and the per-data-block ref_count at the start of each variable/heap data allocation -- with plain non-atomic C operators (buf->ref++, if (--buf->ref > 0), if (--(*ref_count))). The API is documented as self-synchronizing: callers may share one buffer across threads (e.g. via k_fifo) and each holder independently calls net_buf_unref() with no surrounding lock. Under true concurrency (SMP, or single-core preemption between the non-atomic load and store while another context unrefs the same buffer), two holders can both observe the same prior reference value and both conclude they are the last reference. For heap/variable-data pools (mem_pool_data_unref/heap_data_unref, used by zbus message subscribers, the IP stack RX/TX buffers when CONFIG_NET_BUF_FIXED_DATA_SIZE=n, capture, wireguard, ISO-TP and usbip) this produces a double k_heap_free()/k_free() of the same block -- heap-metadata corruption and a use-after-free on the heap-hardening poison pattern. For the per-header refcount the buffer is returned to the pool free LIFO twice for any pool type (including fixed-data pools used by Bluetooth and networking), corrupting the free list so a later allocation hands the same buffer to two owners. The fix converts both refcounts to atomic_inc/atomic_dec (overlaying buf->ref in an atomic_t-sized union and changing the data-block refcount from uint8_t to atomic_t). Impact is gated on genuine concurrency and on an application architecture that shares one buffer among multiple independent unref'ers; the trigger is a refcount/timing race rather than packet content, so an external attacker has at most weak indirect influence over the race window. Affects all Zephyr releases through v4.4.0.

The asynchronous SNTP client in Zephyr (subsys/net/lib/sntp/sntp.c, sntp_close_async) closed the UDP socket file descriptor directly from the calling thread immediately after detaching it from the network socket service, without synchronizing with the socket-service poll thread. The socket service thread polls each socket via zvfs_poll, which (in zsock_poll_prepare_ctx) registers a k_poll_event pointing into the socket's net_context (&ctx->recv_q) and then blocks in k_poll without holding a reference or lock. net_context objects are allocated from a fixed pool (contexts[CONFIG_NET_MAX_CONTEXTS]) and reused after close. When sntp_close_async is invoked from a different thread than the poll thread (in the in-tree consumer subsys/net/lib/config/init_clock_sntp.c, the SNTP timeout handler runs on the system workqueue while the socket service thread is blocked in poll on the same fd), the close frees and may reuse the net_context while the poll thread still has a poller node linked into the freed object, resulting in a use-after-free / object confusion of kernel poll structures. The SNTP timeout path is the normal no-response failure mode, so a network peer or off-path attacker who drops or delays the SNTP/NTP response can drive the racing close repeatedly (and periodically with NET_CONFIG_SNTP_INIT_RESYNC). The most likely consequence is a crash of the networking thread (denial of service), with potential memory corruption when the freed context slot is reallocated. The fix defers the close to the socket service thread itself via net_socket_service_close (NET_SOCKET_SERVICE_CLOSE_SOCKETS), so the same thread that polls performs the close, eliminating the race. Affected releases: v4.2.0 through v4.4.0.