In the Linux kernel, the following vulnerability has been resolved: iommu/dma: Do not try to iommu_map a 0 length region in swiotlb iommu_dma_iova_link_swiotlb() processes a mapping that is unaligned in three parts, the head, middle and trailer. If the middle is empty because there are no aligned pages it will call down to iommu_map() with a 0 size which the iommupt implementation will fail as illegal. It then tries to do an error unwind and starts from the wrong spot corrupting the mapping so the eventual destruction triggers a WARN_ON. Check for 0 length and avoid mapping and use offset not 0 as the starting point to unlink. This is frequently triggered by using some kinds of thunderbolt NVMe drives that trigger forced SWIOTLB for unaligned memory. NVMe seems to pass in oddly aligned buffers for the passthrough commands from smartctl that hit this condition.

In the Linux kernel, the following vulnerability has been resolved: accel/ethosu: reject DMA commands with uninitialized length cmd_state_init() initializes the command state with memset(0xff), leaving dma->len at U64_MAX to signal missing setup. The only setter is NPU_SET_DMA0_LEN; if userspace omits this command and issues NPU_OP_DMA_START, dma->len remains U64_MAX. In dma_length(), a positive stride added to U64_MAX wraps to a small value. With size0 == 1, check_mul_overflow() does not trigger and dma_length() returns 0 instead of U64_MAX. The caller's U64_MAX check then passes, region_size[] stays 0, and the bounds check in ethosu_job.c is bypassed, allowing hardware to execute DMA with stale physical addresses. Fix by checking for U64_MAX at the start of dma_length() before any arithmetic, consistent with the sentinel value used throughout the driver to detect uninitialized fields.

In the Linux kernel, the following vulnerability has been resolved: net: ibm: emac: Fix use-after-free during device removal The driver was using devm_register_netdev() which causes unregister_netdev() to be deferred until the devres cleanup phase, which runs after emac_remove() returns. This creates a use-after-free window where: 1. emac_remove() is called, which tears down hardware (cancels work, detaches modules, unregisters from MAL) 2. emac_remove() returns 3. devres cleanup runs and finally calls unregister_netdev() During step 3, the network stack might still process packets, triggering emac_irq(), emac_poll(), or other handlers that access now-freed hardware resources (dev->emacp, dev->mal, etc.). Fix this by replacing devm_register_netdev() with manual register_netdev() and calling unregister_netdev() at the beginning of emac_remove(), before any hardware teardown. This ensures the network device is fully stopped and unregistered before hardware resources are released. The change is safe because: - dev->ndev is assigned very early in probe (before any error paths that could bypass emac_remove) - platform_set_drvdata() is only called after successful registration, so emac_remove() only runs for fully registered devices - unregister_netdev() is idempotent and safe to call on any registered device

Vim is an open source, command line text editor. From 9.2.0320 until 9.2.0679, a crafted undo or swap file can store a virtual-text property whose offset and length point outside the line's property data. When Vim restores or displays such a line it converts the offset into a pointer and reads the virtual text without bounds checking, causing an out-of-bounds read that can crash Vim or disclose adjacent heap memory. This vulnerability is fixed in 9.2.0679.

In the Linux kernel, the following vulnerability has been resolved: mm/huge_memory: use correct flags for device private PMD entry Commit 65edfda6f3f2 ("mm/rmap: extend rmap and migration support device-private entries") updated set_pmd_migration_entry() to use pmdp_huge_get_and_clear() in the softleaf case, but made no further adjustments to the function itself. Therefore this function continues to incorrectly use pmd_write(), pmd_soft_dirty() and pmd_uffd_wp() to determine whether the installed migration entry should be marked writable, softdirty or uffd-wp respectively. Whilst all are incorrect, the most problematic of these is pmd_write(), as this can lead to corrupted rmap state. On x86-64 _PAGE_SWP_SOFT_DIRTY is aliased to _PAGE_RW. So calling pmd_write() on a softleaf will return the softdirty state encoded in the entry, assuming CONFIG_MEM_SOFT_DIRTY was enabled. This was observed when running the hmm.hmm_device_private.anon_write_child selftest: 1. The test faults in a range then migrates it such that a device-private THP range is established. 2. The parent then migrates it to a device-private writable PMD entry whose folio is entirely AnonExclusive with entire_mapcount=1, softdirty set (accidentally correct write state). 3. The parent forks and the PMD entries are set to device-private read only entries, entire_mapcount=2, softdirty still set. 4. [BUG] The child writes to the range then migrates to RAM - intending to install non-writable migration entries - but replacing parent and child PMD mappings with WRITABLE entries due to misinterpreting the softdirty bit. 5. In remove_migration_pmd(), if !softleaf_is_migration_read(entry) we set the RMAP_EXCLUSIVE flag when calling folio_add_anon_rmap_pmd() for both parent and child, which are therefore AnonExclusive. 6. [SPLAT] Child sets migrated folio entire_mapcount=1, parent sets entire_mapcount=2 and we end up with an AnonExclusive folio with entire_mapcount=2! Assert fires in __folio_add_anon_rmap(): VM_WARN_ON_FOLIO(folio_test_large(folio) && folio_entire_mapcount(folio) > 1 && PageAnonExclusive(cur_page), folio) This patch fixes the issue by correctly referencing the softleaf entry fields for writable, softdirty and uffd-wp in set_pmd_migration_entry(). It also only updates A/D flags if the entry is present as these are otherwise not meaningful for a softleaf entry. This patch also flips the if (!present) { ... } else { ... } logic in set_pmd_migration_entry() so it is easier to understand, and adds some comments to make things clearer. I was able to bisect this to commit 775465fd26a3 ("lib/test_hmm: add zone device private THP test infrastructure") which first exposes this bug as it was the commit that permitted test_hmm to generate the test. However commit 65edfda6f3f2 ("mm/rmap: extend rmap and migration support device-private entries") is the commit that actually enabled this behaviour.

jq is a command-line JSON processor. Prior to 1.8.2, comparing two sufficiently deeply nested arrays with the == operator exhausts the C stack on jq's ordinary command-line surface, resulting in denial of service via stack exhaustion (uncontrolled recursion). The crash occurs in jq's recursive structural comparison code, with the recursion repeating through jvp_array_equal() and jv_equal() in src/jv.c when comparing deeply nested arrays; a nearby sort comparator path through jv_cmp() in src/jv_aux.c overflows the stack at a larger nesting depth from the same missing recursion guard. Anyone running jq comparisons on attacker-controlled deeply nested JSON values, or embedding jq in a context where untrusted data can reach the == comparison path, is affected. This vulnerability is fixed in 1.8.2.

In the Linux kernel, the following vulnerability has been resolved: tcp: restrict SO_ATTACH_FILTER to priv users This patch restricts the use of SO_ATTACH_FILTER (cBPF) on TCP sockets to users with CAP_NET_ADMIN capability. This blocks potential side-channel attack where an unprivileged application attaches a filter to leak TCP sequence/acknowledgment numbers.

In the Linux kernel, the following vulnerability has been resolved: thunderbolt: Reject zero-length property entries in validator tb_property_entry_valid() accepts entries with length == 0 for DIRECTORY, DATA, and TEXT types. A zero-length TEXT entry passes validation but causes an underflow in the null-termination logic: property->value.text[property->length * 4 - 1] = '\0'; When property->length is 0 this writes to offset -1 relative to the allocation. Reject zero-length entries early in the validator since they have no valid representation in the XDomain property protocol.

Vim is an open source, command line text editor. Prior to 9.2.0699, Vim's Python omni-completion (runtime/autoload/python3complete.vim and the legacy pythoncomplete.vim) executes reconstructed function and class definitions from the current buffer with exec() as part of populating the completion dictionary. When reconstructing that source, each scope's docstring is inserted verbatim between triple quotes with no escaping, so a hostile buffer can break out of the triple-quoted literal and execute attacker-controlled Python during omni-completion. This vulnerability is fixed in 9.2.0699.

GitLab has remediated an issue in GitLab CE/EE affecting all versions from 18.10 before 18.11.6, 19.0 before 19.0.3, and 19.1 before 19.1.1 that under certain conditions could have allowed an unauthenticated user to execute arbitrary JavaScript in a user's browser session due to improper path validation under certain conditions.