In the Linux kernel, the following vulnerability has been resolved: nvme-pci: fix out-of-bounds access in nvme_setup_descriptor_pools nvme_setup_descriptor_pools() indexes dev->descriptor_pools[] using the numa_node forwarded from hctx->numa_node by its single caller, nvme_init_hctx_common(). On a non-NUMA kernel hctx->numa_node is NUMA_NO_NODE (-1). Because the parameter was declared 'unsigned', the value becomes UINT_MAX and the index walks off the array (sized to nr_node_ids), faulting during nvme_alloc_ns() and leaving the namespace without a /dev node. Reproduces on any NVMe controller probed by a CONFIG_NUMA=n kernel: BUG: unable to handle page fault for address: ffff889101603d38 RIP: 0010:nvme_init_hctx_common+0x5a/0x190 [nvme] Call Trace: nvme_init_hctx+0x10/0x20 [nvme] nvme_alloc_ns+0x9e/0xa10 [nvme_core] nvme_scan_ns+0x301/0x3b0 [nvme_core] nvme_scan_ns_async+0x23/0x30 [nvme_core] Switch the parameter to int and fall back to node 0 when it is NUMA_NO_NODE; node 0 is always present.

In the Linux kernel, the following vulnerability has been resolved: sctp: fix err_chunk memory leaks in INIT handling When sctp_verify_init() encounters unrecognized parameters, it allocates an err_chunk to report them. However, this chunk is leaked in several code paths: 1. In sctp_sf_do_5_1B_init(), if security_sctp_assoc_request() fails after sctp_verify_init() has populated err_chunk, the function returns immediately without freeing it. 2. In sctp_sf_do_unexpected_init(), the same leak occurs on the security_sctp_assoc_request() failure path. 3. In sctp_sf_do_unexpected_init(), on the success path after copying unrecognized parameters to the INIT-ACK, the function returns without freeing err_chunk, unlike sctp_sf_do_5_1B_init() which properly frees it. Fix all three leaks by adding sctp_chunk_free(err_chunk) calls before returning in the error paths and on the success path in sctp_sf_do_unexpected_init().

In the Linux kernel, the following vulnerability has been resolved: fpga: dfl: add bounds check in dfh_get_param_size() dfh_get_param_size() can return a parameter size larger than the feature region because the loop bounds check is evaluated before incrementing size. If the EOP (End of Parameters) bit is set in the same iteration, the inflated size is returned without re-validation against max. This can cause create_feature_instance() to call memcpy_fromio() with a size exceeding the ioremap'd region when a malicious FPGA device provides crafted DFHv1 parameter headers. Add a bounds check after the size increment to ensure the accumulated size never exceeds the feature boundary.

In the Linux kernel, the following vulnerability has been resolved: dmaengine: dw-edma-pcie: Reject devices without driver data dw_edma_pcie_probe() treats the PCI device ID driver_data as the template for the controller layout and copies it unconditionally. A device bound dynamically via sysfs can match the driver without that data, which leads to a NULL pointer dereference. Reject such matches before enabling the device.

In the Linux kernel, the following vulnerability has been resolved: ASoC: mediatek: mt8192: Release reserved memory on cleanup The MT8192 AFE probe calls of_reserved_mem_device_init() and falls back to preallocated buffers when no reserved memory region is available. When the reserved memory assignment succeeds, however, the driver never releases it. Register a devm cleanup action after a successful reserved-memory assignment so the assignment is released on probe failure and driver unbind.

In the Linux kernel, the following vulnerability has been resolved: usb: atm: ueagle-atm: wait for pre-firmware load in .disconnect() ueagle-atm uses the asynchronous request_firmware_nowait() in .probe(), but does not wait for its completion, not even in .disconnect(); so, if the device is unplugged meanwhile, its teardown runs concurrently with that. Even though this inconsistency is worth addressing on its own, it has also triggered several bug reports in syzbot over the years (some auto-closed) where the firmware sysfs fallback mechanism (CONFIG_FW_LOADER_USER_HELPER) creates a firmware subdirectory in the device directory during its removal, which might hit unexpected conditions in kernfs, apparently, depending at which point the add and remove operations raced. (See links.) The pattern is: usb ?-?: Direct firmware load for ueagle-atm/eagle?.fw failed with error -2 usb ?-?: Falling back to sysfs fallback for: ueagle-atm/eagle?.fw <ERROR> Call trace: ... kernfs_create_dir_ns sysfs_create_dir_ns create_dir kobject_add_internal kobject_add_varg kobject_add class_dir_create_and_add get_device_parent device_add fw_load_sysfs_fallback fw_load_from_user_helper firmware_fallback_sysfs _request_firmware request_firmware_work_func ... (Some variations are observed, after fw_load_sysfs_fallback(), e.g., [1].) While the kernfs side is being looked at, the ueagle-atm side can be fixed by waiting for the pre-firmware load in the .disconnect() handler. This change has a similar approach to previous work by Andrey Tsygunka [2] (wait_for_completion() in .disconnect()), but it is relatively different in design/implementation; using the Originally-by tag for credit assignment. This has been tested with: - synthetic reproducer to check the error path; - USB gadget (virtual device) to check the firmware upload path; - QEMU device emulator to check the device ID re-enumeration path; (The latter two were written by Claude; no other code/text in this commit.) Links (year first reported): 2025 https://syzbot.org/bug?extid=ce1e5a1b4e086b43e56d 2025 https://syzbot.org/bug?extid=9af8471255ac36e34fd4 2024 https://syzbot.org/bug?extid=306212936b13e520679d 2023 https://syzkaller.appspot.com/bug?extid=457452d30bcdda75ead2 2022 https://syzbot.org/bug?extid=782984d6f1701b526edb 2021 https://syzbot.org/bug?id=f3f221579f4ef7e9691281f3c6f56c05f83e8490 2021 https://syzbot.org/bug?id=84d86f0d71394829df6fc53daf6642c045983881 2021 https://syzbot.org/bug?id=3302dc1c0e2b9c94f2e8edb404eabc9267bc6f90 [1] https://syzkaller.appspot.com/bug?extid=457452d30bcdda75ead2 [2] https://lore.kernel.org/lkml/20250410093146.3776801-2-aitsygunka@yandex.ru/

In the Linux kernel, the following vulnerability has been resolved: drm/panthor: validate firmware interface structure sizes iface_fw_to_cpu_addr() only checks that the firmware-provided MCU virtual address points inside the shared section. The returned pointer is later used as a full firmware interface structure, so accepting an address near the end of the shared section can still lead to out-of-bounds accesses. Pass the expected object size to iface_fw_to_cpu_addr() and reject ranges that do not fit entirely in the shared section.

In the Linux kernel, the following vulnerability has been resolved: wifi: mt76: mt7921: fix resource leak in probe error path When pcim_iomap_region() or devm_kmemdup() fail, the code returns directly without cleaning up previously allocated resources: - mt76_device allocated by mt76_alloc_device() - pci irq vectors allocated by pci_alloc_irq_vectors() Fix this by jumping to the existing error cleanup path instead of returning directly.

In the Linux kernel, the following vulnerability has been resolved: ipv6: addrconf: bail out of dad_failure when state is no longer POSTDAD addrconf_dad_failure() transitions ifp->state from DAD to POSTDAD via addrconf_dad_end(), which drops ifp->lock on return. The lock is re-acquired after net_info_ratelimited(). A concurrent ipv6_del_addr() can take the lock in that window, set ifp->state to DEAD and run list_del_rcu(&ifp->if_list). addrconf_dad_failure() then overwrites DEAD with ERRDAD at errdad: and schedules a new dad_work. The work calls ipv6_del_addr() again, hitting the already-poisoned list entry: general protection fault: 0000 [#1] SMP NOPTI CPU: 4 PID: 217 Comm: kworker/4:1 Workqueue: ipv6_addrconf addrconf_dad_work RIP: 0010:ipv6_del_addr+0xe9/0x280 RAX: dead000000000122 Call Trace: addrconf_dad_stop+0x113/0x140 addrconf_dad_work+0x28c/0x430 process_one_work+0x1eb/0x3b0 worker_thread+0x4d/0x400 kthread+0x104/0x140 ret_from_fork+0x35/0x40 Fold the addrconf_dad_end() logic into addrconf_dad_failure() under a single ifp->lock critical section. The STABLE_PRIVACY branch temporarily drops ifp->lock around address regeneration, so at lock_errdad: verify the state is still POSTDAD before transitioning to ERRDAD; bail out otherwise to avoid overwriting a state set by another path while the lock was released.

In the Linux kernel, the following vulnerability has been resolved: ocfs2/dlm: require a ref for locking_state debugfs open debug_lockres_open() copies inode->i_private into struct debug_lockres and debug_lockres_release() later drops that pointer with dlm_put(). That only works if open successfully pins the struct dlm_ctxt. Today open calls dlm_grab(dlm) but ignores its return value. Once the last domain unregister has removed the context from dlm_domains, dlm_grab() returns NULL, yet open still stores the raw pointer and returns success. The later release path is outside the debugfs removal barrier, so it can call dlm_put() after dlm_free_ctxt_mem() has freed the context. KASAN reports this as a slab-use-after-free in dlm_put() called from debug_lockres_release(). Fail the open when dlm_grab() cannot acquire the reference and unwind the seq_file private state before returning. That keeps locking_state from handing out a file descriptor whose release path does not own the dlm_ctxt. The buggy scenario involves two paths, with each column showing the order within that path: locking_state debugfs open: last domain unregister: 1. debug_lockres_open() reads 1. dlm_unregister_domain() calls inode->i_private. dlm_complete_dlm_shutdown(). 2. debug_lockres_open() calls 2. shutdown removes the dlm_ctxt from dlm_grab(dlm) and gets NULL. dlm_domains. 3. open still stores the raw dlm 3. final teardown reaches pointer in dl->dl_ctxt and dlm_free_ctxt_mem() and frees it. returns success. 4. debug_lockres_release() later calls dlm_put(dl->dl_ctxt). Validation reproduced this kernel report: KASAN slab-use-after-free in dlm_put+0x82/0x200 RIP: 0033:0x7f4d349bc9e0 The buggy address belongs to the object at ffff888103a3c000 which belongs to the cache kmalloc-2k of size 2048 The buggy address is located 816 bytes inside of freed 2048-byte region [ffff888103a3c000, ffff888103a3c800) Write of size 4 Call trace: dump_stack_lvl+0x66/0xa0 (?:?) print_report+0xd0/0x630 (?:?) dlm_put+0x82/0x200 (?:?) srso_alias_return_thunk+0x5/0xfbef5 (?:?) __virt_addr_valid+0x188/0x2f0 (?:?) kasan_report+0xe4/0x120 (?:?) kasan_check_range+0x105/0x1b0 (?:?) debug_lockres_release+0x53/0x80 (fs/ocfs2/dlm/dlmdebug.c:587) dlm_put+0x9/0x200 (?:?) debug_lockres_release+0x5c/0x80 (fs/ocfs2/dlm/dlmdebug.c:587) full_proxy_release+0x67/0x90 (?:?) __fput+0x1df/0x4b0 (?:?) do_raw_spin_lock+0x10f/0x1b0 (?:?) fput_close_sync+0xd2/0x170 (?:?) __x64_sys_close+0x55/0x90 (?:?) do_syscall_64+0x10c/0x640 (arch/x86/entry/syscall_64.c:87) irqentry_exit+0xac/0x6e0 (?:?) entry_SYSCALL_64_after_hwframe+0x77/0x7f (?:?) Freed by task stack: kasan_save_stack+0x33/0x60 (?:?) kasan_save_track+0x14/0x30 (?:?) kasan_save_free_info+0x3b/0x60 (?:?) __kasan_slab_free+0x5f/0x80 (?:?) kfree+0x30f/0x580 (?:?) dlm_put+0x1ce/0x200 (?:?) dlm_unregister_domain+0xf6/0xb30 (?:?) o2cb_cluster_disconnect+0x6b/0x90 (?:?) ocfs2_cluster_disconnect+0x41/0x70 (?:?) ocfs2_dlm_shutdown+0x1c4/0x220 (?:?) ocfs2_dismount_volume+0x38a/0x550 (?:?) generic_shutdown_super+0xc3/0x220 (?:?) kill_block_super+0x29/0x60 (?:?) deactivate_locked_super+0x66/0xe0 (?:?) cleanup_mnt+0x13d/0x210 (?:?) task_work_run+0xfa/0x170 (?:?) exit_to_user_mode_loop+0xd6/0x430 (?:?) do_syscall_64+0x3cb/0x640 (arch/x86/entry/syscall_64.c:87) entry_SYSCALL_64_after_hwframe+0x77/0x7f (?:?)