In the Linux kernel, the following vulnerability has been resolved: hwmon: (pmbus/adm1266) include PEC byte in pmbus_block_xfer read buffer adm1266_pmbus_block_xfer() sets up the read transaction with .buf = data->read_buf, .len = ADM1266_PMBUS_BLOCK_MAX + 2, but read_buf in struct adm1266_data is declared as u8 read_buf[ADM1266_PMBUS_BLOCK_MAX + 1]; For a max-length block response (length byte = 255 + up to 1 PEC byte), the i2c controller is told to write 257 bytes into a 256-byte buffer, putting one byte past the end of read_buf. The same response also makes the subsequent PEC compare if (crc != msgs[1].buf[msgs[1].buf[0] + 1]) read a byte beyond the array. Bump the read_buf declaration to ADM1266_PMBUS_BLOCK_MAX + 2 so the buffer can hold the length byte, up to 255 payload bytes, and the PEC byte the i2c_msg length already accounts for.

Improper Isolation or Compartmentalization vulnerability in Apache Syncope. An administrator with adequate entitlements for Implementations can create a malicious Groovy class containing untrusted code bypassing the Groovy security sandbox. This issue affects Apache Syncope: from 3.0.0-M0 through 3.0.16, from 4.0.0-M0 through 4.0.6, from 4.1.0-M0 through 4.1.1. Users are recommended to upgrade to version 4.0.7 / 4.1.2, which fix this issue by tightening the Groovy security sandbox.

In the Linux kernel, the following vulnerability has been resolved: KVM: arm64: Correctly cap ZCR_EL2 provided by a guest hypervisor ZCR_EL2 can be updated by a VHE guest hypervisor either using ZCR_EL2 (which traps) or ZCR_EL1 (which does not trap). KVM handles both in different way: - on ZCR_EL2 trap, ZCR_EL2.LEN is immediately capped at the VM's own VL limit. This has the potential to break existing SW that relies on the full LEN field to be stateful. - on ZCR_EL1 access, we do absolutely nothing. On restoring the SVE context for an L2 guest, we directly restore the guest hypervisor's view of ZCR_EL2 into the physical ZCR_EL2. If the guest's view of the register was updated using the ZCR_EL2 accessor, the value has already been sanitised (with the caveat mentioned above). But if the guest used ZCR_EL1, the raw value is written into the HW, and the L2 guest can now access VLs that it shouldn't. Fix all the above by moving the VL capping to the restore points, ensuring that: - the HW is always programmed with a capped value, irrespective of the accessor being used, - the ZCR_EL2.LEN field is always completely stateful, irrespective of the accessor being used. Additionally, move ZCR_EL2 to be a sanitised register, ensuring that only the LEN field is actually stateful. This requires some creative construction of the RES0 mask, as the sysreg generation script does not yet generate RAZ/WI fields. [maz: rewrote commit message, tidy up access_zcr_el2()]

Windu CMS does not validate types of uploaded files. An authenticated attacker can upload arbitrary files, including PHP. This can lead to Remote Code Execution. Because vendor contact attempts were unsuccessful, the vulnerability has only been confirmed in version 4.1 but may also affect other versions.

dataCycle is a data management system for centrally storing, managing, searching, finding, and distributing data. In dataCycle-CORE, the module handling core processing and framework rules, before and including version 25.07.3, a Standard user can enumerate other users' names and email addresses through `/users/search`, even though direct access to those user profiles is denied. This leaks internal staff addresses, full names, and existence of guest and external test accounts.

In the Linux kernel, the following vulnerability has been resolved: apparmor: fix use-after-free in rawdata dedup loop aa_replace_profiles() walks ns->rawdata_list to dedup the incoming policy blob against entries already attached to existing profiles. Per the kernel-doc on struct aa_loaddata, list membership does not hold a reference: profiles hold pcount, and when the last pcount drops, do_ploaddata_rmfs() is queued on a workqueue that takes ns->lock and removes the entry. Between dropping the last pcount and the workqueue running, an entry remains on the list with pcount == 0. aa_get_profile_loaddata() is an unconditional kref_get() on pcount, so when the dedup loop hits such an entry, refcount hardening reports refcount_t: addition on 0; use-after-free. inside aa_replace_profiles(), and the poisoned counter then trips "saturated" and "underflow" warnings on the subsequent uses of the same loaddata. Before commit a0b7091c4de4 ("apparmor: fix race on rawdata dereference") the dedup path used a get_unless_zero-style helper on a single counter, so the existing "if (tmp)" guard was meaningful. The split-refcount refactor introduced aa_get_profile_loaddata(), which has plain kref_get() semantics, and the guard quietly became a no-op. Introduce aa_get_profile_loaddata_not0(), matching the existing _not0 convention used by aa_get_profile_not0(), and use it for the rawdata_list dedup lookup so dying entries are skipped. Reproduced on x86_64 with v7.1-rc5 in QEMU+KVM running Ubuntu 24.04 + stress-ng 0.17.06: stress-ng --apparmor 1 --klog-check --timeout 60s Without this patch the three refcount_t warnings fire within a few seconds. With it the same 60 s run is clean. Coverage is a smoke-test only; a longer soak with CONFIG_KASAN, CONFIG_KCSAN and CONFIG_PROVE_LOCKING would be welcome from anyone with the cycles.

The Kirki WordPress plugin before 6.0.12 does not sanitise or escape the email subject and body values supplied in a request before including them in the password-reset email it sends as HTML, allowing unauthenticated users to inject arbitrary HTML into the message delivered to a registered user, which can be used for phishing.

In the Linux kernel, the following vulnerability has been resolved: iommupt: Check for missing PAGE_SIZE in the pgsize_bitmap Sashiko pointed out that the driver could drop PAGE_SIZE from the pgsize_bitmap. That is technically allowed but nothing does it, and such an iommu_domain would not be used with the DMA API today. Still, it is against the design and it is trivial to fix up. Lift the PT_WARN_ON to the if branch and just skip the fast path.

In the Linux kernel, the following vulnerability has been resolved: net/iucv: fix locking in .getsockopt Mirror iucv_sock_setsockopt() and wrap the whole switch in lock_sock()/release_sock(). The pre-existing SO_MSGLIMIT-only lock becomes redundant and is removed. Any AF_IUCV HIPER user can potentially crash the kernel by racing recvmsg() with getsockopt(SO_MSGSIZE): the SO_MSGSIZE arm dereferences iucv->hs_dev->mtu after iucv_sock_close() (called from the racing recvmsg()) has set hs_dev to NULL, producing a NULL pointer dereference oops.

In the Linux kernel, the following vulnerability has been resolved: fbdev: fix use-after-free in store_modes() store_modes() replaces a framebuffer's modelist with modes from userspace. On success it frees the old modelist with fb_destroy_modelist(). Two fields still point into that freed list. One pointer is fb_display[i].mode, the mode a console is using. fbcon_new_modelist() moves these pointers to the new list. It only does so for consoles still mapped to the framebuffer. An unmapped console is skipped and keeps its stale pointer. Unbinding fbcon, for example, sets con2fb_map[i] to -1 but leaves fb_display[i].mode set. An FBIOPUT_VSCREENINFO ioctl with FB_ACTIVATE_INV_MODE later reaches fbcon_mode_deleted(). That function reads the stale fb_display[i].mode through fb_mode_is_equal(). The read is a use-after-free. The other pointer is fb_info->mode, the current mode. It is set through the mode sysfs attribute. store_modes() does not update fb_info->mode, so it is left pointing into the freed list. show_mode(), the attribute's read handler, dereferences the stale fb_info->mode through mode_string(). The read is a use-after-free. Clear both pointers before freeing the list. Commit a1f305893074 ("fbcon: Set fb_display[i]->mode to NULL when the mode is released") added the helper fbcon_delete_modelist(). It clears every fb_display[i].mode that points into a given list. So far it is called only from the unregister path. Call it from store_modes() too, and set fb_info->mode to NULL.